ultma 107ci

[bcchop]

has any one used a 107 ci from ultma? I have run the 100's and an 80 and have heard a lot about the larger displacements but not much on the 107's any info?

[fijensen]

I have one, but it hasn't been started yet. It should be a good one. 115 RWHP

[bcchop]

like I said i have run a couple of 100's and 1 80 ci and they have been really good so far, let me know how it runs. I have a line on a 107 unassembled and was just trying to get some feed back before I buy.

[Uncle Spike]

2 of my ridin buddies run 107's and they run the shit out of them non-stop. I'm talkin pretty serious abuse and neither one has had any trouble at all. They try to keep up with me and my 145". They can't, but it doesn't stop them from trying!!

[lorider93]

i run a 120 but not sure about the 107 can not beat it for the money. not to change your mind but pushrod says s&s are going to go down

[pushrod243]

I have used the 107's they run great. Suprisingly they run as good or better than the 113's

[bcchop]

Thanks for the info, I am looking into this motor because I can get a deal on it and i like the ultma motors that I have had so far. but haven't had any experance with this exact size and just wanted to compair. as far as S&S motors I really do not think that they are that much better to justify the cost differance. and I dought that they get as low as i can get the 107. i have 3 rollers and 2 frames in the shop and am looking to start on one of them, hopfuly in the near future.

[soul_hammer]

i have the 107 in my softail and it pulls like a train and gets good milage. it rocks im glad i went for it and not the 96.

[Blaze1975]

I looked at the Ultima website and don't see the 107" listed, where are you finding it?

[fijensen]

It's not one that they advertise a lot. It's not much different than the 113 (5 hp). I have the 107 on my bike. I got it running a week ago, and it will pull your arms out of their sockets. I was surprised at the lack of vibration too. It runs smooth. When I ordered my bike, I wanted a 96". Apparently they had some 107's they needed to unload, cause I got it for less money than a 96. If you look in the engine owner's manual on their website, it's listed in there, with all of the specs etc... It's 115 RWHP, and about the same in torque. 4 inch pistons.

[pushrod243]

The 107 is a great combo less stroke than the 113 so a tiny bit smoother but I have seen some outrun the 113's

[hosh]

I've been looking around at their motors also and i haven't found any one that can beat Jireh Cycles. They have been lower than anyone out there that i have found.