View Single Post
  #26 (permalink)  
Old 07-26-2012, 01:00 AM
CloudDiver's Avatar
CloudDiver CloudDiver is offline
Club Chopper Member
Visit my Photo Gallery
 
Join Date: Apr 2012
Location: San Diego, CA
Posts: 1,103
Not Ranked     
Notice I kept the chain off during this procedure, because the fender is being mounted in the position where the axle will land after chain stretch. Also, the lower bung on this side is short, so i carefully drilled through the frame being careful not to damage the threads of the bung and tapped it again so I can sink a full 1 inch 3/8 stainless bolt from inside the fender.
Reply With Quote